LED Wall Installation: Structure, Power and Access
An LED video wall looks like a screen, but on site it behaves like a heavy, hot, power hungry piece of building equipment. Getting the structure and services right early saves expensive changes once the panels arrive.

Structure first
LED panels are heavy; a large wall can weigh many tonnes once frames and cabling are added. There are three common ways to hold it:
- Ground stacked. Panels sit on a base frame and are braced back to the structure. Common for events and temporary stages.
- Flown or rigged. Hung from a truss or the building structure. Needs rigging points rated for the load and a rigging plan signed off by a qualified person.
- Wall mounted. Fixed to a steel subframe on a permanent wall, typical in clubs, bars, lobbies and retail.
For permanent installs, the subframe and wall need structural sign off. Outdoors, wind load is the deciding factor, and the design must also plan for wind speeds at which the screen is lowered or switched off.
Pixel pitch and viewing distance
Pixel pitch is the distance in millimetres between pixel centres. Smaller pitch means a sharper image up close and a higher price. A widely used rule of thumb is that the minimum comfortable viewing distance in metres roughly equals the pixel pitch in millimetres.
| Use | Typical pitch | Closest viewers |
|---|---|---|
| Boardroom, broadcast | 1.2–1.9 mm | 1–2 m |
| Clubs, bars, lobbies | 2.5–3.9 mm | 3–4 m |
| Event stages indoors | 2.6–3.9 mm | 3–4 m |
| Outdoor stages and billboards | 4.8–10 mm | 5 m and more |
Power and data
- Size dedicated circuits from the manufacturer's maximum power figure, not the average.
- Plan clean power separate from lighting dimmers and kitchen equipment.
- Run data cabling (often fiber for long runs) to a processor position with access for technicians.
- Add surge protection, and a UPS on the processor for permanent installs.
Heat and service access
LED walls produce heat. In enclosed venues, include the screen's heat load in the HVAC design. Decide early between front service panels, which allow a flush wall, and rear service, which needs a maintenance corridor behind the screen.
On event sites
Temporary screens follow the same rules plus the event's structural and weather plan; see temporary event structures. Lifting panels into place uses the equipment planning covered in buy, rent or lease.
Frequently asked questions
How much does an LED wall weigh?
It depends on the panel and pitch, but large walls often weigh many tonnes including frames and cabling, which is why structure and rigging must be engineered.
What pixel pitch do I need for an LED wall?
A common rule of thumb is that the closest comfortable viewing distance in metres roughly equals the pitch in millimetres: about 3 mm for viewers 3 metres away.
Do LED walls need special power?
Yes. They need dedicated circuits sized for the maximum load, clean power separate from dimmers, and surge protection.